Bennett-marine EIC5000 Electronic Indicator Control Manuel d'utilisateur Page 1

(EIC5000)ELECTRONIC INDICATOR CONTROL INSTALLATION AND OPERATION INSTRUCTIONSIMPORTANT - SPECIAL REQUIREMENTS: System is voltage specic. Please make

IMPORTANT: Check Special Requirements noted on the front cover of this manual before beginning installation. If you are installing a preassembled actu

EIC Installation Overviewnipple into actuator upper hinge. Tighten nipple hand tight. Then, with vise grips, tighten two full turns … NO MORE. Cover

Step 10 - Mounting the EIC Relay Module The Module is best located in a dry location close to the Hydraulic Power Unit. Use the mounting hardware to

Calibration and OperationCalibration – NOTE: If you have Upper and Lower Helm EIC Displays installed, calibration must be done at the Lower Helm EIC

Electro-Hydraulic System Information EIC Relay Module Fuse: 12 volt system uses 20 amp in-line fuse on positive, 24 volt uses 10 amp. EIC Display Fuse

2 1/8"3/16"2.832.832 1/8"2"EIC Display TemplateØ 3/4"Ø 5/16"Ø 3/16"Ø 3/16"Ø 3/16"REVISIONSZONEREV.DESCRIP

EIC5000 Electronic Indicator Control – Upper HelmINSTALLATION AND OPERATION INSTRUCTIONSREAD INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATIONSte

EIC5000 Electronic Indicator Control – Upper HelmINSTALLATION DIAGRAM